Reports 560 of 3,120,274 2 filters applied
-
Traffic Signal Repair
Intersection Of New Washington St And Arborway, Jamaica Plain, MaLoose BTD pull box cover sunken in roadway put construction barrel on it to make safe
OPEN · #101002230960 -
Traffic Signal Repair
Intersection Of Congress St And B St, Boston, MaJust witnessed a truck hit the traffic light then drive off. The police was standing right there and didn't stop the driver. They didn't try to get the plate number. I hope no one gets hurt when that last wire snaps. | Signal problem: [Traffic] Type of problem: [Other]
OPEN · #101002224695 -
Traffic Signal Repair
Intersection Of Massachusetts Ave And Saint Botolph St, Boston, MaEvery day between the hour of 6:00am until 6:30am. I am trying to cross from the even side of mass ave to the odd side of the street (Northeastern)...using the traffic light.......during this time the buttons you push to get the walk sign are not working....they do not light up and they are stuck.......later in the morning when i return 10:00am I hit the same buttons and the red light goes on and it says wait.....call me if you have any questions about my issue | Sygnal problem: [Pedestrian Signal] Type of problem: [Pedestrian Button Not Working]
OPEN · #101001750652 -
Traffic Signal Repair
Intersection Of Massachusetts Ave And Huntington Ave, Boston, MaThe constituent is reporting that the button is completely missing. She thinks that it is a safety issue. Also, the walking sign is too faded and vague. | Sygnal problem: [Pedestrian Signal] Type of problem: [Pedestrian Button Not Working]
OPEN · #101001747746 -
Traffic Signal Repair
Intersection Of Morton St And Norfolk St, Mattapan, MaOnly the red turn arrow is out. | Sygnal problem: [Traffic] Type of problem: [No Working Lights]
OPEN · #101001747609 -
Traffic Signal Repair
Intersection Of Ashland St And Bernice St, Dorchester, MaGreen traffic light on Freeport street northbound before morrisey blvd is out. | Sygnal problem: [Traffic] Type of problem: [No Working Lights]
OPEN · #101001521883 -
Traffic Signal Repair
155 Seaport Blvd, 11, Boston, Ma, 02210What is the problem with the traffic signal: [Other] Please explain: [It's not quite at the address -- that's where my office is. When coming off the Pike, at Congress Street, the right turn light doesn't work. I believe we should be able to take a right there, but it's confusing with a no right turn sign that I believe goes with the people coming on the ramp to the right of the westbound Pike exit. Please check it out and if there can be a right turn from the Pike onto Congress, move the sign to the other side of the ramp to the right and fix the right turn light. If not, then put no right turn signs on both sides of the ramp (add one to the left of the ramp) and remove the right turn light that hangs down from the overhead light altogether, or add a no right turn sign to the bottom of the traffic light to make it clear.] What kind of pole is it: [Over the Street Pole]
OPEN · #101001518784 -
Traffic Signal Repair
Intersection Of Brookline Ave And Riverway, Boston, MaIs it a traffic or pedestrian signal problem: [Traffic] What is the problem with the traffic signal: [Controller/Timing Issues] Please explain: [The traffic signal at this intersection for turning left onto the Riverway coming from Brookline Ave (the northern side) are non-standard. Drivers get confused about the right of way during every cycle. This frequently leads to dangerous situations because left turning traffic conflicts with straight going traffic and does not clear before the new cycle of cross-traffic starts! The current set-up is as follows: A 4-light vertical traffic signal with the regular red, yellow, green on top of a green left turn signal. The light cycle is 1) Red only 2) Green + Green Arrow 3) Green only 4) Yellow only 5) Red only. This is confusing, because the top green light stays on when the left turn goes off. This sends mixed messages: to quote the corresponding regulations Federal Highway Administration Code "Shared signal faces shall only be used for a protected-only mode left turn if the circular green and green left-turn arrow indications ALWAYS BEGIN AND TERMINATE TOGETHER". To improve the situation there should be two different signal faces for for straight traffic and turn signals. If my interpretation of the code is correct the signal cycle should then look something like the attached graphic: [with an optional "LEFT TURN YIELD ON GREEN" sign] . All this seems useful to me but I'm obviously no traffic engineer. So I'd be grateful if you could look into this! Because this is the same intersection as in report 101001504531 maybe the traffic light installation / cycles for either turn should be looked at together. I didn't want to combine the two reports because it was getting too long, and the issues *could* in theory be tackled independently even though they should ideally be looked at in conjunction. Thanks a lot for looking into making this intersection better. It's one of the worst spots in Boston/Brookline!] Is the Pole knocked down: [No] What kind of pole is it: [Vertical Pole]
OPEN · #101001504793 -
Traffic Signal Repair
Intersection Of Brookline Ave And Riverway, Boston, MaIs it a traffic or pedestrian signal problem: [Traffic] What is the problem with the traffic signal: [Controller/Timing Issues] Please explain: [The traffic signal at this intersection for turning right from the Riverway onto Brookline Ave: [north] are non-standard and as a result drivers get confused during every cycle. It'd be great to get this fixed. The current set-up is as follows: A 5-light vertical traffic signal with the regular red, yellow, green on top of a blank signal and a green turn signal. The light cycle is 1) Red only 2) Green only 3) Yellow only 4) Red only 5) Red + Green Arrow 6) Red only. This is confusing, because the green light for the right turn only comes on AFTER the red light has come on and cross traffic has started to move. This is highly non-standard and completely unexpected to anyone unfamiliar with this intersection. The first step in improving this situation would be to change the cycle such that the green arrow is already visible when the traffic signal is green for traffic to go straight, i.e., 1) Red only 2) Green + Green Arrow 3) Yellow + Green Arrow 4) Red + Green Arrow 5) Red only. That would be less confusing, but ultimately, what should be done is change the arrangement of the signal and have two different signal faces for straight traffic and turn signals. As stated in the Federal Highway Administration Code "Shared signal faces shall only be used for a protected-only mode right turn if the circular green and green right-turn arrow indications always begin and terminate together". If my interpretation of the code is correct the signal cycle should then work something like the attached diagram. Thanks a lot for looking into making this intersection better!] Is the Pole knocked down: [No] What kind of pole is it: [Vertical Pole]
OPEN · #101001504531 -
Traffic Signal Repair
Intersection Of Fenway And Westland Entrance, Boston, MaIs it a traffic or pedestrian signal problem: [Traffic] What is the problem with the traffic signal: [Flashing/Blinking] Please explain: [Fenway southbound is flashing yellow and Fenway northbound is flashing red. Northbound traffic is not getting a chance to go because southbound traffic is steady.] Is the Pole knocked down: [No] What kind of pole is it: [Over the Street Pole]
OPEN · #101001502690
Hold Shift to view percentages